gas condensing boiler turkey

Energy-saving condensing boiler turkey which brand is good, this is the majority of customers are more and more concerned about the problem. With the domestic attention to air pollution control, the surrounding areas of Beijing, Tianjin and Hebei in China have issued control measures according to the actual situation, among which the elimination of small coal-fired boilers is one of the important measures. Gas-fired boilers, oil-fired boilers and electric heating boilers all belong to energy-saving boilers, but compared with coal-fired boilers with serious pollution, the fuel cost is still higher, which increases the use costs of customers. Customers are also more concerned about the energy-saving effect of boilers, as far as possible to reduce costs. So which brand of energy-saving boiler is good? Now push for you. Recommend national A class boiler high-tech enterprise-Fangkuai boiler. Energy-saving boiler is a series of products that we focus on research and development of Fangkuai boilers. The thermal efficiency of natural gas boiler is very high, our Fangkuai can reach 95% or more, the emission of gas is very friendly to the environment, the nitrogen oxide is less than 30mg, which meets the relevant rules and regulations in our country. In some of the more remote areas, some countries have limited power to factories. At this time, the oil-fired boiler is a good place, with the domestic improvement of fuel quality, Fangkuai The continuous development of new technology has greatly improved the energy-saving effect of the boiler. Electric boilers can be said to be a leader in environmental protection boilers, but electricity is a valuable secondary energy source, and most of them are converted from coal-fired thermal power generation. Some areas are still short of electricity supply, and there is also a power limit every summer peak. Therefore, it is not the domestic promotion of energy-saving boilers. Another reason is that it costs about twice as much as a gas-fired boiler. Again, we strongly recommend a new type of energy-saving boiler-tubular boiler, which has a combustion efficiency of up to 96% and is very friendly to the environment, that is to say, the special performance of 3-minute steam output is available as soon as it is opened. Can save you a lot of fuel. Some customers may think that compared with traditional boilers, the price is a little more expensive, but what we have to say is that we have reasons for expensive, high-tech applications have greatly improved thermal efficiency, saved a lot of fuel, from the long-term investment use, The price-to-performance ratio is super high. Through the above understanding of energy-saving boilers, I believe you have a certain understanding of our Fangkuai boiler brand, want to have a more in-depth understanding, please call our hotline, more sincerely invite you to visit the plant, study.

With the increase of air supply volume, the mixture of oil mist and air is improved, which is beneficial to combustion. However, if the air volume is too large, the furnace temperature will be decreased and the incomplete combustion loss will be increased. At the same time, the heat loss of exhaust gas will be increased and the power consumption of the fan will be increased because of the increase of flue gas. If the air volume is insufficient, the combustion will be incomplete, resulting in carbon deposition at the tail, which is prone to secondary combustion accidents. Therefore, each condensing boiler turkey should pass the thermal efficiency test to determine its economic air volume at different loads. In practice, the stoves usually take into account the ignition of the nozzle and the carbon dioxide or oxygen content in the flue gas. Content to adjust the supply air volume. If it is found that the combustion condition of a nozzle is not good, or if the atomization plate with different aperture is replaced, the air pressure of the supply duct should be kept unchanged, and the opening degree of the duct baffle of the nozzle should be adjusted to normal combustion. If the fuel quantity changes due to the change of the oil pressure in front of the furnace, the opening of the fan baffle should be adjusted to achieve normal combustion by changing the air pressure and air volume of the air supply duct when it is necessary to adjust the supply air volume.

3) the observation and analysis of all kinds of flame when adjusting the fuel oil. Generally through the fire point adjustment and flame center adjustment to complete the flame adjustment. The ignition point of the oil mist should be close to the nozzle, but there should be no tempering. Early ignition is beneficial to complete combustion and stability of oil mist. However, the fire is too early, too close to the nozzle, easy to burn the nozzle and furnace wall to determine the mouth. Furnace temperature flying oil varieties and atomization quality, as well as air volume, wind speed and oil temperature, will affect the distance and proximity of the ignition point. So if you want to adjust the ignition point, you should find out the cause in advance, and then take targeted measures. When the boiler load is constant and the oil pressure and oil temperature are stable, Should be based on the ignition point wind speed and wind distribution situation.

At the end of 2017, China Guodian is located in Jiangxi Province Wanan Hydropower Plant After evaluating the situation, some of the steam condensing boiler turkey used to purchase much-needed daily work. Sales Manager fast boiler combined with the actual situation of the power plant for its recommendation 2 0.5 tons of electrically heated steam boilers.

Fuel gas control step and the blowing process air volume of the total fuel gas steam condensing boiler turkey steam boiler is achieved by adjusting a liquid coupling scoop blower. Organization fuel gas steam boiler combustion, is to make a, air pressure, air flow of secondary air with the good. Adjusting the amount of primary air should meet it carries the fuel into the furnace ignition of volatile oxygen required, and to maintain a certain speed, and without clogging the fuel discharge pipe of the jet having a certain rigidity. Primary air volume is too large and too small, the wind speed is too high and too low, should be avoided. In addition to adjusting the secondary air of combustion of the fuel should ensure that the oxygen demand, but must maintain a certain wind speed and primary air is mixed with the master time should have a strong stirring and mixing coke penetrate "the Gray" kinetic , which requires the case may be, each layer of the secondary air flow rate, in order to achieve stable combustion and flue gas excess oxygen appropriate destination. Fuel gas steam boiler, secondary air with what is better? Primary air volume air volume of the total share is called the primary air rate. A small air fraction, pulverized coal is heated to at least the heat required for the ignition point, fire faster, but the amount of primary air to satisfy the principle of combustion of volatiles. Secondary air mixed with the primary air time to the right. If it is mixed before ignition, means an increase in the amount of primary air, so that the ignition delay; hypoxia combustion secondary air if mixed will make late after ignition; if secondary air is mixed all at one position, since the secondary air temperature well below flame temperature, the flame temperature decreases, the combustion slows down, causing the fire. Therefore, the secondary air mixed with fuel should be based on the nature of the combustion zone as required timely sent, so that the combustion of oxygen, and will not reduce the flame temperature to ensure complete combustion and ignition stability. One or two wind speed with what is better? Fuel gas steam boiler once the wind speed is high, the fuel gas stream will catch fire in places far away from the burner, the ignition point postponed; once the wind speed is too low, it will cause a blocked ducts, and ignition point is too far forward, the burner will burn , but also easy to coke near the burner.