electricity natural gas steam atmospheric pressure boiler for sale

Multi-fuel capabilities

Under the contract, ZG will deliver the 158 MW thermal CFB unit with flue gas cleaning and other auxiliary equipment including assembly and commissioning.The multi fuel steam boiler will be designed to burn up to 100 percent biomass, which will consist mainly of wood chips from forest residues and forest industry by-products. It is also designed to use peat and coal as additional and/or alternative fuels.

Details installed gas electricity natural gas steam atmospheric pressure boiler for sale combustion system that we need to pay attention when installing a gas boiler combustion system, inviting professional staff in advance of the circuit diagram design, so that when installing the status line installation will not appear unreasonable. Also, pay attention to install some fire-fighting equipment, which can provide protection for our security. Unit ventilation should generally remain the total combustion air amount at the rated load. Combustion process controller provides a separate set of contact start-stop control. May be formulated in a variety of burner start-stop loop cascade control relay 10A is a fuse, relay start-stop control stops the control terminal may be connected to the burner, may directly control the power of the burner. Both constant pressure sensor, water power, fuel, gas pressure set value is detected after the automatic controller opens. Time pressure sensor, water supply, oil, gas, and their detection circuit, alarm and found the problem immediately shutdown flame protection, the controller automatically displays the point of failure, an alarm sounds machine. Installation room oil, gas line gas boiler, boiler room should be strictly in accordance with design, specification, and should refer to the burner. Fuel system pressure test after installation is complete, should be 1.25 times the working pressure (minimum test pressure of not less than 0.4MPa). After the fuel pipe installation system should be flushed with water or steam flushing, flushing should have approved technical measures, the number of washing is not less than the secondary blowing, blow up until the clean medium, should be cleared after the purge debris and dead. After installation of fuel system should be oil circulation system-wide test. The gas should be the shortest route to the burner, the air supply pipe diameter must be larger than the constant value parts of the burner duct.

2. Oxygen corrosion

For the biomass fuel boiler pressure parts,the water side is mainly electro chemical corrosion,the fire side (or flue gas side) is mainly chemical corrosion.The oxygen corrosion belongs to electrochemical corrosion, it is mainly caused by the dissolved oxygen in water.At room temperature,the dissolved oxygen concentration is about 9.1mg / L,according to the GB1576-2001 “industrial boiler water quality” requirement ,the rated steam pressure should not be more than 1.0MPa,the dissolved oxygen concentration should not be more than 0.1mg / L,otherwise,it is likely to lead to metal corrosion.

Fang faster work on clean fuel electricity natural gas steam atmospheric pressure boiler for sales more than twenty years, whether it is research and development or manufacturing fields have achieved remarkable results. The launch of the "Euromonitor 5" series boilers, the company's new low-nitrogen boiler, using advanced FGR combustion technology, nitrogen oxide emissions below 30mg / m3, our first-tier cities can be used normally. Remote monitoring system is to attract the attention of the participants. Jumping curve data, real-time display operating status boiler; detailed data analysis and fault early warning program, Fang fast "black technology", making the boiler to get rid of "silly Big Ben rough" image and become intelligent high-tech incarnation.