power station natural gas steam atmospheric pressure water tube boiler for sale

Released by the heating device (burner) heat transfer by radiation is first absorbed waterwall waterwall Boiling water, a large amount of steam into the drum for water separation (excluding DC furnace), separated saturated steam enters the superheater , and it continues to absorb the top horizontal flue furnace by radiation, convection, heat of the flue gas flue of the tail, and the superheated steam to reach the required operating temperature. Power generation power station steam atmospheric pressure water tube boiler for sales are generally provided with a reheater, it is used to heat the steam through the high pressure cylinders acting reheater go out of the reheat steam, the low pressure cylinder to continue to generate power. Popular terms, the steam boiler is to absorb combustion heat of the fuel into the water some parameters (such as pressure, temperature, etc.) of the steam device. Boilers and boiler furnace divided into two parts, the pot is filled with water to a metal container, partially combusted fuel furnace, the heat absorption of the water inside the pot furnace fuel combustion converted to steam, with the basic principles of almost boiling water, the pot equivalent kettle, oven stove equivalent. 1, by fuel, our existing steam boiler fuel that can be used are: gas boilers, coal-fired boiler, oil-fired boiler, electric heating boilers, nuclear boilers, waste heat boiler, etc., of which the first four of the most common.

After use throughout the winter, the Central Conservatory of Music give us feedback, six V6-99 fully meet the heating needs of the school. And power station steam atmospheric pressure water tube boiler for sale fuel and water requirements are not high, urban water and low-pressure natural gas combustion can operate. The most important point is that nitrogen oxide emissions are very low and very happy to recommend it to others to do the brother of boiler units. --customer feedback

Run time, and the thermal conductivity of the gas power station steam atmospheric pressure water tube boiler for sale gas boiler after its long run, inevitably its scale and corrosion problems in the use of the process, the main reason the gas boiler scale formation is due to the water with ingredients hardness, high temperature, high pressure continuously concentrated by evaporation. Gas boiler furnace in which it is running a series of chemical and physical reactions will occur during use will effectively form a dense and hard scale on the heating surface, which would lead directly to lower the heat exchange efficiency and due to corrosion under the scale factors, it will lead to reduced boiler water wall furnace heat absorption. The outlet temperature of the gas boiler furnace during the course of an increase, so that losses will increase in the boiler, it will be effective to reduce the heat transfer in the water wall fouling equipment, so it is very likely to cause the water-cooled wall tube wall temperature results in an increase of the thermal conductivity of scale squib gas boiler waterwall at runtime only a few tenths of a steel material, when its heating surface fouling, so that the heat transfer will be impeded, in use process in order to maintain a certain boiler output, it is necessary to raise the temperature of the fire side. During the washing process gas boiler which may be employed in an efficient and environmentally friendly non-corrosive cleaning agent for cleaning the boiler, so that the device will expose the metal tube primary colors, because the reduction of algae and biological sludge fouling effect. Note that after the need for effective gas boiler furnace during ignition of smoke was observed and the temperature of the main steam temperature, the case where the pressure rise of the main steam, which is encountered after the boiler ignition temperature of tobacco will significantly increase the speed of the smoke or temperature Pianman It does not rise to the herd to immediately check the oil gun fire conditions.

11.Steam exiting the high pressure steam turbine is called cold reheat.

It is reheated in the re-heater and sent back to the second steam turbine. By the time the flue gas exits the boiler most of the energy in the coal will be transferred to the water in the boiler. The hot gases are cleaned up before they are sent to a stack. Feed water is generally supplied by condensed steam from the low pressure steam turbine. Large amounts of cooling water are used to condense this steam into liquid water in the condenser.