1 ton gas fired boiler in kenya

The party soon provide us with three hot water 1 ton fired boiler in kenya output foot, gas combustion, efficiency is very high, for us to save a lot of fuel costs. Moreover, these hot water boiler can be achieved by adjusting the full 24 hours a use hot water to meet the daily needs of old people. --customer feedback

The low-nitrogen gas 1 ton fired boiler in kenya adopts the international leading condensing combustion technology, and the nitrogen oxide emission is as low as 30mg/m3, which not only fully meets the requirements of Beijing's low nitrogen emission standards, but also reaches the world leading level of low-nitrogen emission combustion technology. Coupled with the high safety of ZBG oil and gas boilers and up to 95% thermal efficiency, ZBG oil and gas boilers have achieved low nitrogen emissions and greatly saved energy, making them the first choice for self-service heating for domestic and foreign customers.

Multi fuel design CFB 1 ton fired boiler in kenya Challenge

Multi-fuel CFB boilers typically burn a mixture of waste or alternate fuels along with natural gas, fuel oil,or pulverized coal.This provides an opportunity to produce steam at lower cost than a basic fossil fuel fired unit, but it also makes operations more challenging.Waste and alternate fuels vary in Btu content per volume and their supply is often not consistent. This significantly affects combustion stability and the ability to reliably meet load. More expensive fossil fuels must be used when waste and alternate fuel is not available or to make up for low Btu. Managing this without excessive cost is difficult.In addition, operating within emissions constraints may be a problem with multiple fuel streams in the mix.

Teach you how to properly operate a steam 1 ton fired boiler in kenya: steam boiler before use to conduct the inspection of the damaged insulation, burner check to see whether the normal operation, also check to ensure that the open position of the valve is correct, check the device controlled device instrumentation and safety equipment accessories, equipment must meet the requirements. Steam boiler furnace entry point confirmation are: Open the valve before and after the oil circulation pump, oil heating flow valve opens, the liquid level in the sump reasonable mediate high position, confirmed that the gas pressure before ignition of the gas burner to the range, the power supply is normal .