Henan newly installed gas boiler 1 what kind of work before starting. Henan newly installed gas boiler before starting what should be done? These include: the tightness of (1) hydrostatic test (overpressure test), test pressure member. (2) Trial and various auxiliary electric door damper check. (3) oven. Water inside wall of the furnace and gas water boiler tubes Henan removed. (4) cooking stove and pickling. Remove grease deposits in the evaporator heating surface system, rust, oxide scale and corrosion products, and other like with lye and acid. (5) furnace aerodynamic field test. (6) flushing pipe. Henan boiler with gas flushing a self-generated steam, the second steam duct heteroaryl residue. (7) check security doors. 2. Henan gas boiler before start time and temperature of water on what regulations? why? Water speed before the start of Henan gas boiler should not be excessive, winter generally less than 4h, other seasons 2 ~ 3h, especially in the beginning of the water should be slow. Cold boiler water temperature is generally not more than 100 ℃, so that the temperature difference between the feedwater entering the drum drum wall temperature is not more than 40 ℃. Henan not completely cooled gas boiler drum water temperature, mutatis mutandis, wall temperatures, generally the difference should be controlled within 40 ℃, it should slow down or speed water. The reasons are: (1) Since the thick-walled drum, slow expansion, the wall of the tube is connected to the drum wall is thin, expanded rapidly. If the inlet water temperature is too high or too fast, uneven expansion will cause the weld cracks occur, resulting in damage to the equipment. (2) when the water supply enters the drum, the drum is always in contact with the first half wall, if the water temperature and the drum wall temperature difference is too large, the influent fast speed, on the drum, the lower wall, the inner and outer wall inter will have a greater expansion difference, caused a large drum to additional stress, causing deformation of the drum, when severe cracks.

Hot water boiler which is not equipped with no impact can cause demineralizer 1, the waste fuel boiler fouling occurs, resulting in poor heat transfer performance of heating surface, so that heat generated by the combustion of the fuel can not be timely delivered to the boiler water, but a large amount of heat is smoke away, resulting in exhaust gas temperature is too high, if the exhaust gas loss increases the thermal efficiency of the boiler will be reduced. In order to maintain the nominal parameters of the boiler, fuel must be increased, thereby wasting fuel. About 1 millimeter scale waste fuel ten percent. 2, the heat receiving surface is damaged due to deterioration of the heat transfer performance, fuel combustion heat is not quickly transmitted to the boiler water, resulting in the furnace and the flue gas temperature. Thus, the temperature difference on both sides of the heating surface increases, the metal wall temperature, a decrease in strength. Under pressure pot, bags and even blasting will occur. 3. Reduce heat boiler output due to the deterioration of the performance of boilers, need to consume more fuel to reach the nominal rate of evaporation. However, with the increase in the scale thickness, the volume of the furnace becomes large, the fuel consumption is limited. Therefore, it is possible to reduce the output of the boiler. 4, the corrosion damage to the metal: oxygen in the water, acid, base materials will corrode the metal surface of the boiler, it is thinned, recess or perforation, thus reducing the power of the boiler, seriously affect the safe operation of the boiler. 5, in addition to improper operation Priming outside, when the boiler water contains more sodium chloride, sodium phosphate, and silicides oil, boiling or evaporation process boiler water, boiler water occurs when soap and organic base when Teng because soda will produce compost. Foam liquid surface, formed soda pool. No softening, easily scalable. Due to the continuous evaporation steam, boiler of calcium, magnesium, high impurity concentration is 30-50 times that of natural water, fouling rate beyond our imagination, only six months to a year, from 1-2 mm.

Finally, the delegation went into the manufacturing plant, the robot welding expressed strong interest in the robot field operations after watching the situation, I am using for manufacturing more refined variety of highly intelligent boiler equipment expression of praise. Mr. Liu is also the site to watch the robot control platform, careful observation stations located at the edge of the station systems. Side of photography Henan Daily reporter Chen Hui spoke to the tour group members in the field, this robot is currently in the province is a "little red network", has been the provincial media repeatedly reported.

Biomass boiler for paper mill

ZG Boiler have been commissioned by many paper mill in many countries to undertake extensive servicing activities on a high-pressure steam boiler. we have gas fired boiler, biomass fired boiler, coal fired boiler to paper mill.