oil and gas hot water boiler for aquaculture industry

Regular maintenance of electric boilerIn general, the electric boiler should be repaired and maintained within 1 ~ 2 years, which is helpful to the normal operation of the electric boiler. For the electric boiler, regular maintenance is also the basic to ensure its normal operation. 1, when maintaining and maintaining the boiler, Must cut off the power supply, must release pressure. 2, burners should be removed from the boiler body every two months, carefully remove carbon deposits and dust and other foreign matter. The photo-electric tube is polished once a month. The fuel filter should always be cleaned and filtered. Carefully clean the inner filter screen of the oil pump and do not destroy the gasket. The burner shall not be idle without oil to prevent damage to the oil pump. 3. The water level gauge shall be kept clean at all times. Open the cleaning valve once a day to keep the water level clear. 4. The safety valve is pulled once a day in case of rust failure. After the work, check if the tools, materials, accessories are complete, to prevent remaining in the furnace and other spaces. Special person delisting, acceptance and acceptance of qualified before leaving the work site, final maintenance records, in order to prepare after the inquiry.

Steam Boiler Types in Pharmaceutical Industry

ZG Boiler as a professional industrial steam boiler manufacturer, has all types of industrial boiler supplies, such as coal fired steam boiler, biomass fired steam boiler, oil & gas fired steam boiler, waste heat steam boiler, CFB steam boiler to customers. And pharmaceutical boiler types can vary depending on fuel source, unit location, emissions, boiler controls, and heating requirements, and coal, oil, gas, biomass energy are the main pharmaceutical boiler fuels. ZG Boiler can guarantee the customers obtain the highest efficiency of the pharmaceutical boiler by repairing or upgrading super heaters, water well panels, power and process piping, drums, and more.

Application of heating Boiler Control systemThe heating boiler is equipped with a special microcomputer controller for oil and hot water boiler for aquaculture industry, large screen full Chinese liquid crystal screen, with super bright backlight, no matter day or night, the operation status of the boiler is clearly visible. Complete display: circulating pump working condition, burner working condition, furnace water temperature, water level, current time, alarm record, etc., boiler operation condition is all available; Easy to set: after the boiler starts, the operator can enter the standby state (setting), enter the running state (start), exit the running state (stop), and set the running parameters at will when the boiler is on standby. Full-featured: you can set the current time at any time , alarm temperature, water temperature upper limit temperature, water temperature lower limit temperature, circulating pump opening temperature, circulating pump closing temperature, boiler switching time (can be divided into 4 time periods) and other operating parameters. Usually the operator just press; start the start key, press; Stop the key stop can, very simple use of the original imported burner, fully automatic programmed control, fan automatic blowing, electronic automatic ignition, automatic combustion of oil and gas, air and oil (gas) automatic proportional adjustment, atomization effect is good, combustion is full, Energy-saving and environmental protection, with extinguishing protection device to ensure the safety of combustion. Under normal conditions, the burner output automatically adjusts the length of the combustion flame with the boiler temperature When the outlet temperature of the boiler reaches the set value, the burner automatically stops burning, and when the temperature is below the set value, the burner starts to work automatically. When the fuel and intake air are abnormal, the fault light is on, the program control device will stop outputting the fuel immediately, and the burner will stop automatically.

First Affiliated Hospital of Bengbu fully implement the national environmental protection policies, strict screening of clean boiler as the supply of medical supplies disinfection and ward heating equipment. Fast boiler with its focus on research and development of clean-type gas boiler two decades of experience in the industry favored. The partnership, to provide fast boiler First Affiliated Hospital of Bengbu Medical College, a WNS20-1.25-YQ one condensing steam boiler, in terms of design, manufacture, installation and other aspects of strict checks to enhance the thermal efficiency of the boiler as well as truly Energy saving and environmental protection.