how to obtain agent price 10t industrial steam boiler jordan capacity in kilowatt

First, let's talk about the boiler capacity unit, "Megawatt (MW)", "kilowatt(Kw)", "W", "Kcal/h", "horsepower(hp, bhp,)", "ton per hour(t/h, tph, ton)", "lbs/hr", "Btu/Hr", "Lbs/Hr" or kg/hr. These are the units that describe the boiler capacity (boiler power, boiler heat), there is an equivalent relationship or a comparison relationship between them.

Fang fast open class formal lecture: products, services both hands April 18, Fang fast open class smooth commencement, partners from across the country converge in the exchange of learning party headquarters R & D building fast training room, professional trainers to share a boiler features, installation and operation precautions, commissioning maintenance process, rapid fault verification, and troubleshooting tips, and other professional knowledge, students listen carefully, positive answer questions, and the atmosphere is very active.

Boiler maintenance boilers way with the development of society, more and more people use, during use, we can not forget its care and maintenance, which also have a specialized technical maintenance, the following teach everyone boiler routine maintenance: 1, all oil cups are filled with oil. 2, at all events are required to add oil. 3, the bottom of the boiler water is not ground plane, to prevent wet etching of the base. 4. The grate shall tighten or loosen, four bolts on the housing shall relax the base beforehand. 5, when the induced draft fan to severe vibration should stop checks, generally based internal impeller wear or fouling caused by severe and should be replaced. 6, class check grate reducer, the tap head and gear lubricants induced draft fan in the bearing housing is held within the allowable range, light fuel should be promptly, to clean up oil leakage. 7, the gland gasket lower portion of the slag, as grout leakage found, litter should be kept pressed, or replaced with a new temporary parking gasket stop leakage, and check if grout leakage into the bearing, should be open the cleaning. If you want long-term use can improve the efficiency of the boiler and then you need to do routine maintenance and repair, of course, if handled properly there may be accidents happen, you have to be before they can according to the correct method.

Pressure hot water boiler proper use of which pressurized hot water boiler as a high temperature and high pressure safety of energy equipment, it has been widely used in many enterprises. However, the presence of pressurized hot water filtered using a number of limitations must be strictly in accordance with operating instructions, or it may be pressurized hot water boiler damage, even fatal accidents. Even a good brand of pressurized hot water boiler was not spared, so the user needs to know how to properly use pressurized hot water boiler. A and can not fracturing the boiler hot water boiler, high pressure hot water boiler has essential differences, pressure hot water boiler and hot water boiler and a method for producing a pressure significantly different quality, pressure hot water boiler by direct communication with the atmosphere the air pressure is always maintained in a fixed condition, the pressure will follow the hot water boiler water temperature and pressure changes. In practice, the pressurized hot water boiler can not be used by boiler pressure, it can not be arbitrarily modified. Second, maintaining boiler accessories intact pressurized hot water boiler with a water level gauge, pressure gauge, safety valves and other safety accessories, it is also equipped with water level alarm and over-pressure alarms, many ways to ensure the safety of pressurized hot water boiler. These security zones are pressurized hot water boiler and operator tool of communication and communication, its integrity is important for the safe use of high pressure hot water boiler. Third, the maximum pressure not excess pressure boiler pressure hot water boiler is set at the factory. In everyday use, the pressure of the boiler pressure value should not exceed the maximum set by the factory. Set the maximum pressure value are based on standard test material thickness and boilers. Users can not change.