Steam boiler rules Henan fast boiler with small series to introduce the company's oil fired steam boiler for aac production line operating procedures. First, the components of the steam boiler before oven cooking oven and check (a) and oven cooked boiler furnace must be checked in detail. Check the following items: 1, cold chain grate test more than 24 hours, cold test should meet the following requirements: (1) grate should be smooth turning chain wheel axle, found arched, two tension bolts can be tightened. (2) the active grate sprocket good occlusion. Minimum gap (3) on both sides of the active grate block with the side seal and the side seal angle not less than 6 mm. Distance (4) on both sides of both ends of the furnace grate platoon leader pin in the sprocket should be kept equal. If it is found at one end to the occurrence of side friction, long waist-hole may be a tap with a hammer, the end surfaces on both sides remains equal distance. (5) steam boiler grate rotated without jamming, deviation phenomenon, when the deviation found by the inspection hole into the rear grate tail, the tie bolt align the two bearings of the drum, deviation phenomenon can be eliminated. The boiler has ignition combustion, still need to transfer found Hearth n, just before two adjustable chain tensioning bolt shaft directly outside the furnace, but preceded align the front sprocket shaft and a gearbox connect the safety pin or bolt removed until after squaring shaft to a gearbox with a chain alignment pin or bolt after tightening, may otherwise result in misalignment with the sprocket shaft of a gearbox and mechanical damage. (B) Check broken grate furnace platoon leader pin is bent, if long waist hole in the furnace may be carried out at any time platoon leader pin alignment reload. (C) a chain grate does not allow foreign matters (such as bolts, nuts, nails and other iron) is present. (D) firing door open and flexible, easy to open and drop the shutter coal, coal gate left and right side of the grate surface distance equal to, the thickness of both sides of the seam to ensure equal furnace, as a method for reducing ranging from links available to make equal, coal shutter cover plate should cover tightly to prevent leakage into the coal, coal stuck shutter. (Five) of each grate windshield of smoke damper and damper adjustment inside the flue flexible switch. (Vi) blower, Fan, Java machine, commissioning normal water supply equipment. (Vii) manhole, hand hole is tight, attached parts fitted Ge are complete. (Viii) the furnace wall is normal, the flue is tight. (Ix) steam boiler pipes, water pipes, sewage road is complete. (J) all filled with lubricating oil in the bearing housing and oil cup. (Xi) All electrical equipment should be empty running test, inspection equipment, and other electrical lines is intact.

Special Requirement: ASME gas fired oil fired steam boiler for aac production line

ASME Gas Fired Steam Boiler Manufacturer in Oil Refinery in Syria

The essay serve a documented basis for joint project of erection and operation of biomass residue firing CHP (Combined Heat and Power) unit. 58 tons/hour of steam at 12 barg are generated in few heavy oil firing boilers and consumed in production process. The basic assumptions are that saw dust or/and wooden chips with LHV (Low Heating Value) 18,000 kJ/kg will be fired in a fluidized bed boiler producing about 30 ton/hour steam (about a half of needed process steam). The steam flow, passing through a back pressure turbine, will generate electricity corresponding to difference of enthalpies of fresh steam generated in the boiler and of one needed for process. From the turbine outlet the steam will be used, as today, for the technological process of the factory.

Union Focus Group on democratic management to enhance, 2018 in the weekly publication of the level of reward single award, with only mechanism in the process of division and promote all kinds of competition, in a difficult time helping employees aftermath of experience, the group promoting the union all the time our staff carry out positive changes in the basis of life.