Commercial Factory Price 1t gas steam boiler Azerbaijan

The wns oil and gas commercial factory price 1t steam boiler azerbaijan produced by zbg is fast assembly installation boiler. And the steam boiler is equipped excellent automatic control burner to realize full automatic performance.

Details installed gas boiler combustion system that we need to pay attention when installing a gas boiler combustion system, inviting professional staff in advance of the circuit diagram design, so that when installing the status line installation will not appear unreasonable. Also, pay attention to install some fire-fighting equipment, which can provide protection for our security. Unit ventilation should generally remain the total combustion air amount at the rated load. Combustion process controller provides a separate set of contact start-stop control. May be formulated in a variety of burner start-stop loop cascade control relay 10A is a fuse, relay start-stop control stops the control terminal may be connected to the burner, may directly control the power of the burner. Both constant pressure sensor, water power, fuel, gas pressure set value is detected after the automatic controller opens. Time pressure sensor, water supply, oil, gas, and their detection circuit, alarm and found the problem immediately shutdown flame protection, the controller automatically displays the point of failure, an alarm sounds machine. Installation room oil, gas line gas boiler, boiler room should be strictly in accordance with design, specification, and should refer to the burner. Fuel system pressure test after installation is complete, should be 1.25 times the working pressure (minimum test pressure of not less than 0.4MPa). After the fuel pipe installation system should be flushed with water or steam flushing, flushing should have approved technical measures, the number of washing is not less than the secondary blowing, blow up until the clean medium, should be cleared after the purge debris and dead. After installation of fuel system should be oil circulation system-wide test. The gas should be the shortest route to the burner, the air supply pipe diameter must be larger than the constant value parts of the burner duct.

Recently, Hangzhou Provincial People's Government for the quality of atmospheric environment issues issued a deadline for compliance plan, as follows.

First, the situation and challenges

Since the "Atmospheric ten" implementation of Hangzhou to build an ecological civilization as a guide to improve the quality of atmospheric environment as the goal, carry out air pollution prevention and control actions to protect the G20 summit in Hangzhou as an opportunity to promote a strong "coal-fired flue gas, industrial emissions , vehicle exhaust, dust gray gas, urban and rural exhaust "other" gas cohabitation ", strengthen regional joint prevention and control, air pollution control and achieved remarkable results, no built coal-fired thermal power, iron and steel producers no, no emission vehicles "three noes" urban atmospheric environmental quality continues to improve.

(A) Key Performance

1, ambient air quality improved significantly.

In the case of the national economy with an average annual growth of 9.1% of the "second five" major pollutants emission reduction achieved remarkable, sulfur dioxide, total nitrogen oxide emissions compared to 2010, respectively, decreased by 21.9%, 26.5%, exceeding the state-assigned the reduction targets and tasks.

2, energy and industrial structure gradually optimized.

The city's total energy consumption growth narrowed year by year, total energy consumption in 2015 was 39.48 million tons of standard coal, an average annual increase of "Twelfth Five-Year" period is only 3.4%, compared with the "Eleventh Five-Year" down 2.1 percentage points.

3, industrial pollution prevention deepened.

Promoting desulfurization and denitrification and dust removal facilities, coal-fired thermal power generating units are completed desulfurization, denitrification facilities, a total of 87 coal-fired thermal power generating units ultra-low emissions transformation.

4. The motor vehicle exhaust pollution prevention and continuous progress.

"Twelve Five" period, and comprehensively promote the yellow car out of work in 2015, the city basically eliminated emission vehicles.

5, comprehensively promote urban and rural waste gas treatment.

"Twelve Five" period, to strengthen the construction site dust management, the establishment of civilized city construction sites and construction dust pollution comprehensive rectification work leading group, the establishment of municipal, district, enterprise level management network.

6, continue to strengthen capacity building.

"Twelve Five" period, the construction of Hangzhou, air pollution control system for continuous improvement, introduced the "Hangzhou pollution prevention provisions of the atmosphere", and the issuance of the annual air pollution control plan and supporting the implementation of assessment methods.

(B) there is a problem

1, ambient air quality improvement into the bottleneck.

In recent years, the effectiveness of atmospheric environmental quality improved significantly, but control "Ambient Air Quality Standard" (GB3095-2012) secondary standards are still gaps.

2. Regional collaborative governance is still run-in period.

The analysis results Hangzhou PM2.5 sources, the contribution to the local discharge air in an urban environment PM2.5 concentration 62% -82%, about 72% on average. Regional transport to urban ambient air concentrations of PM2.5 contribution accounts for 18% -38%, an average of about 28%, in different seasons affect the Hangzhou area varies. A higher proportion of regional transport and complexity of the transmission source region to control air pollution in Hangzhou more difficult to establish and improve regional air pollution is critical institutional mechanisms of joint prevention and control.

3, into the deep water of air pollution control.

In recent years, Hangzhou, air pollution prevention and control work has achieved remarkable success, but there are still many "shortcomings" in the current governance of air pollution, structural, further highlights the deep-seated problems.

(1) optimize the industrial structure needs to continue, heavy pollution in some areas, high energy-consuming industries and the "messy dirty" business issues are still quite prominent.

Total coal (2) Energy consumption is still high, the use of natural gas supply capacity and scale need to be strengthened, industrial parks (industrial parks) are still blind spots of central heating, renewable energy development and utilization efforts still need to increase.

(3) heavy end of the treatment, the light source control and cleaner production, the work of "second five" major emission control measures revolve around the end of pollutants on source control and cleaner production process is still insufficient attention.

(4) With SO2, NOx reduction work continued in-depth, project emissions space shrinking, VOCs emissions is more a lack of technical means, the rigidity of the vehicle population growth, vehicles, ships and non-road mobile machinery and other mobile source pollution control to be a breakthrough. With the difficulty of the work of prevention and control of atmospheric pollution key areas continue to increase, the city is still on air pollution control into the deep water.

4, the basic work is still weak period.

Municipal government attaches great importance to air pollution control work, work-related basis more solid, but there are still many weak links. Hangzhou, organization and leadership of atmospheric pollution control systems should be strengthened, the department division of labor, the working mechanism of collaborative governance needs improvement. Local standards should be further improved, pollution resources and a list of atmospheric pollution still need to be updated regularly.

At present several common boiler energy-saving technologies: usually for boiler manufacturers, it means that you are saving boiler to maximize the interests of customers, providing customers with unlimited fuel savings, the electricity consumption, water consumption and so on. But the wide range of energy-saving, does not refer to an aspect of optimization can save energy boilers, here's a look now common boiler energy-saving technologies: 1 furnace arch. Industrial boiler furnace arch is very important. Arch role is to cause the furnace hearth and the organization of the mixed gas and the radiation hot flue gas flow, ignition and combustion of the fuel in a timely manner. At present, the actual amount of industrial commercial factory price 1t steam boiler azerbaijan with its rated load often do not match, the use of coal varies widely, but often with the design coal are quite different, so in actual use, often as necessary for the furnace arch modified to meet the needs of coals. Heteroaryl coal used by the inferior design coal, the boiler furnace exit gas temperature occurs is low (about 700 degrees), lower than 200 degrees design.